My Philips Garment Steamer leaves stains on the garment
If your Philips Garment Steamer leaves stains, or you notice impurities coming out from it, there might be a simple solution. Find out how to solve this issue in the following lines.
Scale built up in the steamer
- If your steamer is not descaled regularly, it is normal for scale to build up in your garment steamer, and this can cause it to release some impurities or produce stains.
To solve this, please descale your steamer. The descaling process depends on your product and series. Please find here all descaling information for your Philips Steam Iron or Steamer
Note: The solution above does not applies to GC625, GC626, GC627, GC610, GC612, GC617, GC618 models.
Chemicals or additives are added into water
- If you used any chemical or additive with your Philips Garment Steamer, fill the water tank with water and allow it to steam out 1 full tank to rinse off chemical residues from the appliance.
For stains on the garment, rinse off any stains under running water.
For stains on the steamer head, wipe any deposits off the steamer head with a damp cloth.
Note: The chemical or additives (e.g. perfume, essential oil, vinegar, etc) cause damage to the appliance. Do not use any chemical or additive with your garment steamer.
High level of water hardness
- Depending on where you stay, the water hardness level may be high and results in fast scale build-up in your garment steamer.
Ensure that water tank is emptied after a steaming session. It is recommended to use a combination of demineralized/distilled water (50%) mixed with tap water (50%).
At the start of a steaming session, set the steam setting to the MAX mode. Hold the steamer head away from the garment and press the steam trigger for 10 seconds to release the initial gush of water droplets.
For stain on the garment, rinse off any stains under running water.
For stain on the steamer head, wipe any deposits off the steamer head with a damp cloth.
Note: The solution above only applies to GC625, GC626, GC627 models.
Did these solutions not help to solve the issue? Please contact us for further assistance.